Oerlikon CITOSTEEL 255C Manual De Instrucciones página 31

Note: The jobs which are disabled can not be using in
"Save memory" function – shown in Figure 51 (job 2 is
not available).
Figure 51.
Select Jobs for Job Work – it allows to
choose which jobs will be enable when Job
Mode will be activated.
To select Jobs for Job Work:

Access to the Settings and Configuration Menu.

Use the Right Knob [36] to highlight the icon.
Figure 52.

Press the Right Knob [36] to confirm.

Use the Right Knob [36] to highlight the job number.

Press the Right Knob [36] to confirm – the icon of
chosen parameter will appear on the lower part of
the display.
Figure 53.

Press Button [37] to return to main menu.
English
Job Mode
with selected jobs.
Note: First of all user have to select jobs
which can be used in Job Mode (Access Control ->
Select Jobs for Job Work)
To activate Job Mode:

Access to the Settings and Configuration Menu.

Use the Right Knob [36] to highlight the Job Mode
icon.

Press the Right Knob [36]. The Job Mode Menu is
shown on the display.

Use the Right Knob [36] to highlight one of the option
shown on the figure below.
X
- Cancel Job Mode

- Activate Job Mode

Press Right Knob [36] to confirm the selection.
Note: After activated Job Mode the icon of this function
will be displayed on the Welding Parameters Bar. Also
the Load Memory and Save Memory options will be
blocked in this mode.
27
– user has access to operate only
Figure 54.
Figure 55.
English