Operation; Before First Use; Boiling Point Calibration; Inserting Hand Grip - Gaggenau VK 414 610 Manual De Instrucciones

Operation

Before first use

Bear in mind the following instructions before
steaming for the first time:
1 Thoroughly clean the appliance and accessories.
2 You must calibrate the boiling point when setting up
the appliance.
3 Fill the cooking basin with cold water up to the
minimum mark. Fit the glass cover.
4 Press in the temperature control knob, turn it to the
¥
position and steam for 30 minutes. The
appliance now calibrates the boiling point.
5 After boiling point calibration, drain the water and
thoroughly dry the cooking basin.
Notes
‒ Steaming without previously calibrating the boiling
point can cause malfunctions on the appliance. It is
possible that too much or too little steam will be
produced.
‒ Extra steam may emerge from the appliance during

boiling point calibration.

‒ Do not interrupt boiling point calibration and do not
open the glass cover. The appliance must steam for
30 minutes.
Boiling point calibration
The boiling point is dependent on air pressure. As air
pressure drops with increasing elevation, the boiling
point drops as well.
Before steaming with the steamer for the first time, you
have to calibrate the boiling point. You must repeat
boiling point calibration after moving to a new location.
The steamer then adapts to the air pressure at its
installation site.
Calibrating the boiling point
1 Fill the cooking basin with cold water up to
minimum mark. Fit the glass cover.
2 Turn the temperature control knob to the 200°F
(95°C) position.
3 Within 5 seconds: Turn the same temperature
control knob back and forth
position and 200°F (95°C) and then turn the
control knob to the
The appliance now calibrates the boiling point. This
takes around 10 minutes. Do not open the glass cover
during boiling point calibration.
12
twice between the
¥
position.
Note: Extra steam may be produced during boiling point
calibration.

Inserting hand grip

9
WARNING
Risk of burns
The cooking insert becomes very hot. Only
remove the cooking insert with the provided hand
grip. The hand grip must engage securely on the
cooking insert. The hand grip is not appropriate
for turning over the cooking insert to empty its
contents.
1 Press the hand grip into the slot on the cooking
insert.
2 Fold the hand grip back. Lift up cooking insert with
hand grip.

Turning on

Fill the cooking basin with cold water or any other
cooking liquid (1 - 4 liters; see also the cooking table).
You must not fill the cooking basin with oil. It must be
filled at least up to the minimum mark or up to no more
than the spill edge.
Press in the temperature control knob and turn it to the
desired temperature. You can set the temperature from
100 - 200° F (45 - 95 °C). Set the steam cooking setting
¥
for steam cooking.
¥