Num'axes PIE1069 Manual De Instrucciones página 26

When the memory card is full, the LCD screen indicates "Memory full".
5. Operation
5.1. Turn ON the camera
Put the switch in the ON position; the camera is ready to work.
The red start-up indicator light located on the front cover will blink and the LCD
display will count down 5 seconds. This interval allows you time to close the camera
front cover and leave the monitored area.
Once in the ON mode, the camera will take photos and/or videos according to its
current parameter settings.
NOTE: the camera comes pre-programmed with factory default settings. So, for test
purpose, you only need to insert the memory card and AA batteries then power on
the camera (switch in the ON position).
5.2. Turn OFF the camera
Slide the switch to the OFF position to turn off the camera. Please note that even in
OFF mode, the camera still consumes power at a very low level. Therefore, please
remove the batteries if the camera will not be used for a long time period.
The OFF mode is the "safe mode" for actions such as: replacing the memory card or
batteries, or transporting the camera.
5.3. Buttons functions in SETUP mode (selector in SETUP position)
Press this button twice to enter the settings MENU.
Press this button once to start the REPLAY mode.
Allows you to take a photo or start recording a video and then
stop it. In this mode, the video length is not limited.
Allows you to check the charge level of the AA batteries.
Switch to Photo mode.
Guide PIE1069 – Mai 2023 – ind. A - 26/116