Num'axes PIE1069 Manual De Instrucciones página 36

Time lapse
Camera password
Cycle recording on
memory card
Power supply
External power supply
Stand-by time
Operating
temperature
Storage temperature
Humidity
Watertightness
Dimensions
Weight
8. Troubleshooting
8.1. The photos do not capture subject of interest
− Check the PIR sensitivity parameter setting. In warm environmental conditions,
set the sensor sensitivity to "High" and in cold weather use, set the sensor
sensitivity to "Low".
− Try to set your camera up in an area where no heat sources are in the camera's
field of view.
− In some cases, setting the camera near water will make it take images with no
subject in them. Try aiming the camera over ground.
− Avoid setting the camera up on small trees that are prone to being moved by
strong winds. Try to set the camera on stable and immovable objects, i.e., large
trees.
− Remove any limbs which are right in front of the camera lens.
− At night, the PIR sensor may detect beyond the range of the infrared flash.
Reduce the detection distance by adjusting the PIR sensor sensitivity.
Programmable
Programmable
Programmable
Solar panel with built-in rechargeable lithium battery
(3.7V – 4400mAh)
4 x AA alkaline or rechargeable Ni-MH batteries
(optional)
5V/1A
Outdoors: almost unlimited battery life thanks to the
solar panel
Indoors: approximately 12 months
-20°C to +60°C
-30°C to +70°C
5% - 90%
IP66
143 x 107 x 95 mm
404 g (without batteries) | 496 g (with batteries)
Guide PIE1069 – Mai 2023 – ind. A - 36/116