Num'axes PIE1069 Manual De Instrucciones página 29

Time Lapse
Cycle recording
IR LED brightness
Low power night
capture
Operating periods
smoke, near window, etc. This will prevent untimely
triggering
OFF | ON
With "Time Lapse" ON, the camera will capture photos or
videos automatically at a pre-set time interval.
WARNING: when the Time Lapse parameter is set to
ON, the PIR sensor is deactivated (there is no motion
detection).
Select "ON" then press OK to set the interval; the camera
will shoot photos or video clips automatically upon the
user set interval.
Time Lapse programmable from 00:00:05 up to 23:59:59.
Example: if Time Lapse is set to 00:30:00, the camera will
automatically capture photos/videos every 30 minutes.
The "Time Lapse" feature can work together with the
"Operating periods" feature.
OFF | ON
When the memory card will be full, the camera will
continue to record photos/videos by deleting the oldest
photos/videos.
Select "OFF" then press the OK button to deactivate the
cycle recording function.
Auto | Medium | Low | OFF
This parameter allows you to adjust the brightness of the
infrared flash
No IR flash | No capture
‒ No IR flash: At night, if the power level is too low
(solar panel battery, AA batteries), the device will
take photos/videos without triggering the infrared
flash.
‒ No capture: at night, if the power level is too low
(solar panel battery, AA batteries), the device will no
longer take photos/videos.
OFF | ON
Each day, the camera will work only during the user set
time period(s).
programmed.
Guide PIE1069 – Mai 2023 – ind. A - 29/116
Two different periods can be