klover STARBOX 650 Instrucciones Para La Instalación, El Uso Y El Mantenimiento página 57

MAINTENANCE
10.7 CLEANING OF THE COMBUSTION CHAMBER
l
Recommended cleaning frequency: consult the para-
graph "Scheduled maintenance".
Before proceeding with the cleaning operations, any
■
unburned pellets left in the brazier must be removed.
To dispose of any ash, consult the paragraph
■
disposal".
TOOLS TO BE USED; brush with soft bristles (NOT
■
supplied), ash vacuum device equipped with a fine-
mesh filter in order to prevent part of the ash from
being blown into the room.
d
Do not use abrasive sponges or wet cloths and do
not place the surfaces in direct contact with the pipe
of the ash suction device.
Do not use water to clean the inside of the combus-
■
tion chamber.
To clean the combustion chamber, proceed as follows:
- open the door of the appliance –, consult the paragraph
the door"
- clean the fire bed, consult the paragraph
- remove the upper fire bricks, consult the paragraph
fire bricks" support the side bricks during the operation to prevent
them from falling
- dust the surfaces of the combustion chamber gently using a brush
- use a suitable ash cleaner to suck up combustion residues.
CS.STB.IST-1_EN_Rev.1.0_08-23
"Ash
"Opening
"Fire bed cleaning"
"Removing the
Fig. 32
10.8 FIRE BRICK CLEANING AND REPLACEMENT
l
Recommended cleaning frequency: consult the para-
graph "Scheduled maintenance".
Before proceeding with the cleaning operations, any
■
unburned pellets left in the brazier must be removed.
To dispose of any ash, consult the paragraph
■
disposal".
TOOLS TO BE USED; brush with soft bristles (NOT
■
supplied).
d
Do not use abrasive sponges or wet cloths and do
not place the refractory bricks in direct contact with
the ash suction machine's tube.
Do not use water to clean the surface of the refrac-
■
tory bricks.
To remove and clean the fire bricks, proceed as follows:
- open the door of the appliance –, consult the paragraph
the door"
- remove the fire bricks, consult the paragraph
bricks"
- dust the surface of the refractory bricks gently using a brush.
10.9 CLEANING THE FLUE GAS CHANNEL
The flue gas channel must be cleaned depending on how frequently
the fume exhaust system tends to accumulate dirt, but nonetheless
ALWAYS at the start of the winter season, and whenever necessary.
The flue gas channel MUST be cleaned at least once a year.
l
Recommended cleaning frequency: consult the para-
graph "Scheduled maintenance".
Before proceeding, carefully read the chapter
■
gas channel".
Consult the paragraph
■
the ash.
a
Cleaning must be performed ONLY by an authorised
KLOVER Technical Assistance Centre or by qualified
personnel.
a
It is also important to check for any obstructions in
the flue before switching the appliance on following
long periods of inactivity. If the flue is not cleaned,
the operation of the appliance and of its components
could be hampered.
"Ash
"Opening
"Removing the fire
"Flue
"Ash disposal" to dispose of
EN
27