Poolex ICE SPA Manual De Usuario Y Instalacion página 116

4. Set heater or circulation pump (optional)
In the "Settings" menu, use the "Special" button
Parameters L8 and L10 must be enabled to use this menu.
– If L8 = 0, the circulation pump relay cannot be activated manually.
– If L10 = 0, the heater relay cannot be activated manually.
See "Modify user settings", page 16, to enable or disable these options.
The use of these two relays is described in more detail in "5. Use of optional control relays", page 21.
5. Set time and date
In the "Settings" menu, use the "Date / Clock" button
on the screen. Date and time are also useful for error history reliability (see page 21).
The value entered in each box must be possible to be taken
into account. The date format is: month - day - year.
A value greater than 12 cannot be entered in the month box.
6. Set display brightness
In the "Settings" menu, use the "Brightness" button
Tip: Use the extension cable to store the control panel away from light. The shade will
ensure better visibility of the screen.
7. Reset settings
In the "Settings" menu, use the "Reset" button
A code is required. Contact the After Sales Service.
You will be asked to confirm your wish to reset the settings.
Confirm
When the parameters are reset, the message "Initialization secceeded" is displayed.
18 | EN
4. USE
OF CONTROL PANEL
Switch e-heater relay to manual mode
Switch circulation pump relay to manual mode
Slide the slider to the left to decrease brightness,
or to the right to increase it.
to access the following interface:
to change the date and/or time displayed
to modify screen brightness.
to reset the parameters.
Cancel