Publicidad
Idiomas disponibles
Idiomas disponibles
English
Owner´s manual
Special safety instruction for battery tool
1. Make sure the battery switch is in "OFF" position before insert battery. The equipment can
be damaged if inserting the battery at switch on.
2. Charger design for use only indoor. Charging operations have to be performed indoor.
3. Disconnect power before to clean the charger to avoid damage and risk of electrical shock.
4. Don't expose battery in strong light. Don't put battery on hot surface. It can cause battery
explosion.
5. Fully cold battery before charging.
6. Don't disassemble the battery, don't damage battery, in order to avoid injury.
Use charger correctly
1. Use the battery charger only with rechargeable cells. Otherwise, it may cause fires and
explosions. Use only the original battery charger.
2. Always check the condition of the charger, cable and plug before each use. If damaged,
always contact a service technician for repair or replacement. Do not use damaged
chargers. Do not attempt to repair the damaged battery charger to keep the tool safe.
3. Verify that the output voltage and charger connector match the proper battery, failure to do
so could result in personal injury and damage to the tool.
4. Disconnect the charger before activating the battery switch.
5. Keep the charger clean, away from humid environments and rain. Do not use the charger
outdoors.Dirt and water may cause damage to the charger and personal injury.
6. The charger is designed for use with original batteries only, other uses may be dangerous
and may cause fire or explosion.
7. Do not use damaged or malfunctioning chargers.
8. Do not use the charger on flammable surfaces (e.g. paper, wood, etc.).
9. The battery is not sold fully charged, it must be recharged for 2.5 hours before first use. (the
LED on the charger will turn from red to green to indicate full charge).
10. Normal charging time is 2.5 hours. Do not charge the battery for too long to avoid
damaging the battery. Charge the battery only when the red LED indicator on the battery is
activated, this will ensure longer battery life. will.
11. Before charging, please turn off the power switch, because when changing, it is normal for
the charger and the batteries to have high temperature.
12. New batteries or batteries that have not been used for a long time will reach the maximum
capacity after 5 charge-charge cycles.
13. Do not charge the batteries repeatedly after several minutes of operation, as this may
reduce the working time and the efficiency of the batteries.
14. Do not use damaged batteries or do not disassemble the charger or the batteries.
15. Do not charge the batteries outdoors or in humid environments.
16.With the gradual deduction of the amount of electricity from the battery, it is normal for the
shear diameter capacity to be reduced.
17. Do not use pruning shears during the charging process.
Residual risk
Keep use the tool carefully avoid risk as below:
1. Cutting or injuries due to sharp edges
2. Use for long periods of time or in incorrect positions may cause damage.
28
Publicidad
