Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION!
Check the tool before starting work and make sure that the main switch is working properly.
The scissors should stop when the trigger is released. Do not use the scissors if the switch
is malfunctioning. Check that the battery voltage matches the power of the tool.
Conditions of use
- Keep the ambient temperature between 4°C and 40°C during the reloading phase.
- Keep the tool temperature between -10°C and 50°C during use.
- Do not use in an explosive atmosphere or near flammable materials or liquids.
- Do not use in case of rain, or on wet branches.
Initial work process
Turning on the pruning shears
Install the lithium battery. Press and hold the power switch for three seconds until you hear the
double beep. The scissors are now ready for use.
Activating the cut:
Once the pruning shears have been turned on, press the trigger twice in succession to
activate it and be able to start using the shears.
Before starting to work with the machine, press the latch several times and observe how the
blade works. If you detect any strange phenomena (sound, abnormal and non-progressive
speed); keep pressing until its operation is normalized.
Activation of the "blade closed" standby mode
For your safety, the appliance has a "standby mode", which closes the scissors blades and
deactivates the cutting function.
To put the scissors in standby mode: press the trigger continuously. You will hear a first beep.
Keep pressing the trigger until you hear a subsequent double beep. The scissors will be
closed.
To deactivate the standby mode and activate cutting: Press the trigger twice. The scissors are
now ready for use.
Opening mode selection
You can change the cutting size of the scissors according to your needs.
Press the trigger continuously. After a few seconds you will hear a beep, but you should keep
pressing until you hear two more beeps. When you have heard them, you can release and the
diameter of the cutting opening has been changed.
Activating / Deactivating progressive cutting
Progressive cutting allows greater control over the cut, as the cut changes according to the
pressure you exert on the trigger.
To activate or deactivate this function: with the scissors off, press and hold the trigger. Turn on
the scissors without releasing the trigger, wait about 6 seconds until you hear a beep. Once
the beep has been heard, the progressive mode will have been activated or deactivated.
English
Owner´s manual
31
Publicidad
