Publicidad
Idiomas disponibles
Idiomas disponibles
English
Owner´s manual
7. MAINTENANCE AND CLEANING
Faulty tools must be repaired by the authorized technical service. Use only original parts, this
will ensure the correct operation of the tool.
ATTENTION!
Turn the battery off and disconnect the tool before checking, repairing or cleaning it to
prevent it from starting accidentally and causing injury or cuts.
- Do not wet or spray the tool with water or any other liquid and do not immerse it, it may
cause a short circuit inside the tool.
- Keep the handle clean, do not add supplements or elements that may hinder the ventila-
tion of the motor. Use a cloth to clean the tool. Do not use detergents to clean it as this may
damage the surfaces.
- Clean the blade after each use, protect it with protective oil.
Cleaning and greasing. Replacement of blade or counter blade. Disassembly
and assembly.
This process is very important because it determines the quality of the cut, the life of the blade
and the life of the battery. The more difficult it is to cut, the more your appliance consumes.
The wear of the blade should be controlled and checked daily and on a regular basis, you
should sharpen and lubricate the blade daily. Blades in poor condition or poorly sharpened bla-
des overload the tool. Damage resulting from use with poorly sharpened blades is not covered
by warranty.
- After opening the blade, please turn off the battery.
- Both sides of the movable blade are polished using sharpening stone forming the angle of
the section with the blade.
- After polishing the blade, wash it, connect to the power line, test, close the blade and finish.
34
WARNING
Wear protective gloves before handling the blade.
When cleaning your scissors, keep the following considerations in mind.
Frequent checking of the tool will make it safe and reliable.
Publicidad
