English
Owner´s manual
1. Always make sure the battery is dry and clean before charging.
2. Make sure the battery is fully charged before first time using.
3. The battery is not fully charged when purchased, recharge it for 2-2.5 h before using it for
the first time.
4. Recharge the battery when indicated by the LED indicator.
5. Do not charge batteries over 5 hours, don't use up completely otherwise battery life will be
reduced.
6. The battery should be replaced if the battery life becomes insufficient. Use only original
batteries supplied by the manufacturer.
7. Keep safety rules and environment protection information in mind all the time.
Battery charging procedure
1. Recharge in a closed environment at a temperature between +10°C and 22°C (+59°F and
68°F).
2. Make sure the battery switch is in the off position before starting to charge.
3. Correctly connect the battery charger to its connection.
4. Make sure that the correct charger is used for the battery before starting to charge.
5. The red LED on the battery charger indicates that charging is in progress, the green LED
indicates that the battery is fully charged. The average charging time is about 2-2.5 h.
6. Disconnect the connector from the battery charger at the end of charging.
7. Ensure that the battery is recharged at least every 3 months during storage periods.
9. LOAD LEVEL SWITCHES
Tool battery level
The pruning shears have an integrated digital display (point 5) where you can see the percentage of
battery level of the tool.
The model DPS32002/ DPS32002 also has a LED display, where you can also see the battery capacity.
When the green light is illuminated, the battery capacity is adequate for operation.
Battery charge status (charger)
WARNING!
Make sure your charger is in good condition. Check that there is no dust or dirt on the connector
and, if so, clean it and make sure it is dry.
10. WASTE DISPOSAL AND ENVIRONMENTAL PROTECTION
Move battery from equipment; recycle battery, tool, accessory and package to kind of waster.
36
LED
Bright red
Green light
Remove the battery from the device and recycle the equipment, batteries,
accessories and packaging in an environmentally friendly manner.
State
Loading
Finished cargo