Publicidad
Idiomas disponibles
Idiomas disponibles
Cutting procedure
Danger of amputation and serious injury.
Wear suitable gloves when using the machine.
The sensor of the anti-cutting system, for those models equipped with it, may
be affected by the use of gloves, so take special care.
Wear protective goggles.
1. To make the cut, position the branch between the blade and the counter-blade and press
the trigger.
2. When the device is running, keep the other hand at least 15 centimeters away from the
cutting area of the blade, never place your hand on the blade while the scissors are on.
3. As a precaution, keep bystanders at least 1.5 m away.
4. The blade may deteriorate or become blocked if you try to force the cut on branches that
are too large or too dry.
5. Do not handle the tool during the cutting phase, it may be dangerous.
6. Do not use the tool in the rain or in damp environments.
7. We recommend that after daily use, you should turn off the scissors and remove the battery
from the scissors and place them inside the complementary case.
ATTENTION!
In case of difficulty in cutting, check the battery charge and the correct sharpness of the
blade.
During the cutting process, if the cutting blade encounters a branch that it cannot cut, it
locks and stops, release the trigger to return to the open position, after which the next cut
can be carried out normally.
ATTENTION!
Do not force the blade sideways to avoid damaging the cutting edge of the blade. Check the
operating frequency of the blade to verify the correct working condition of the blade.
DANGER!
The blade may take some time to stop. Do not touch the blade while it is
moving to avoid risk of injury or accident.
Storage
After use, remove the lithium battery pack and clean the blade.
English
Owner´s manual
33
Publicidad
