Publicidad
Idiomas disponibles
Idiomas disponibles
4
Duct and accessories installation
4.1 Duct
1.
Install the filter (optional) according to the size
of the air inlet.
2. Install the canvas tie-in between the body and
duct.
3. The air inlet and air outlet duct should be far
enough apart enough to a avoid air passage
short-circuit.
4. Connect the duct according to the following
diagram:
Ceiling-mounted
Canvas tie-in
Air outlet
Isolation
booth
Wall-mounted
NOTE:
1. The min. length of the duct should be
more than 1m, and fix on the air inlet by
screws (applicable to the unit that the air
inlet filter is not fasten by screws).
2.The inlet of the air duct needsto be
installed with a grille, which needs to be
fixed to the air duct with screws.
3.Do not place the connecting duct
weight on the indoor unit.
4.When connecting the duct, use an
nonflammable canvas tie-in to prevent
vibrating.
5.Insulation foam must be wrapped
outside the duct to avoid condensate. An
internal duct underlayer can be added to
reduce noise, if the end-user requires.
6.When the machine is wall-mounted,
the machine should be concealed
mounting, and the air inlet and outlet
should be grille, and the grille should be
fixed firmly with screws.
Canvas tie-in
Isolation booth
Duct
Air inlet
checking
orifice
Air dust filter
4.2 Wall mounted installation (middle
pressure)
The unit supports
purchased with a pump and requires vertical
mounting, please follow the steps below:
1. Remove the electrical control box cover, unplug
the pump and water level switch terminals from
the main control board.
2. Disassemble the pump components.
Grille
3. Remove the 4 screws, rotate the water
pump components by 90° and fix them to
the water pump mounting plate again.
4. Install the pump parts to the machine and
connect the wiring set.
24
wall
mounted, if the unit is
V.1
Publicidad
