Publicidad
Idiomas disponibles
Idiomas disponibles
6
Fresh air duct installation (middle pressure)
Dimension :
MODLE
12K~48K
Ø100mm(3.93")
Motor and drain pump maintenance (middle pressure)
7
(The rear ventilated panel is used as an example)
1) Motor maintenance:
1.
Take off the ventilated panel.
2.
Take off the blower housing.
3.
Take off the motor.
Drill wall hole for connective piping
8
1. Determine the location of the wall hole
based on the location of the outdoor unit.
2. Using a 65mm (2.5in) or 90mm(3.54in)
(depending on models )core drill, drill a
hole in the wall. Make sure that the hole
is drilled at a slight downward angle, so
that the outdoor end of the hole is lower
than the indoor end by about 12mm (0.5in).
This will ensure proper water drainage.
3. Place the protective wall cuff in the hole. This
protects the edges of the hole and will help
seal it when you finish the installation process.
Duct joint for fresh air
Ø125mm(4.92")
Ø126mm(5.0")
Motor
Blower housing
Ventilated panel
28
MODLE
48K~60K
2) Pump maintainance:
1.
Remove four screws from the drain pump.
2.
Unplug the pump power supply and water
level switch cable.
3.
Detach the pump.
CAUTION
When drilling the wall hole, make
sure to avoid wires, plumbing, and
other sensitive components.
Outdoor
≈ 12mm / 0.5 inch
Ø160mm(6.3")
Pump
Wall
Indoor
V.1
Publicidad
