Publicidad
Idiomas disponibles
Idiomas disponibles
Water tank: 2.7 litres; Dimensions: 31,5*25*37 cm
Weight: 10.2 kg - To be operated with ground coffee and coffee pods
PL042TEMD-120: 120v: 60Hz, power: 1200W
PL042TEMD-AS: 220V: 60Hz, power: 950W
TROUBLESHOOTING:
Dear Customer, we thank you for buying one of our products, conceived and assembled in accordance with the most up-to date
technological innovations. Follow carefully the simple operations of use contained in this manual, which comply with essential
safety regulations, you will get the best performances and notice the remarkable reliability of this product along the years.
You find here below an easy table describing some malfunctioning of the machine with its solutions:
PROBLEM
Coffee is produced
without "cream".
Coffee too cold
Coffee produced too
quickly
Coffee leaks between
the coffee group and the
filter-holder
Coffee is produced in
drops
The machine does not
produce steam
No coffee produced
during the coffee cycle
The machine does not
work and the ON light
does not go on
The ON light is on and
the steam light does not
go on after 10 minutes
The inserted data and pictures can be subject to changes without previous notice for the improvement of the machine's
performances.
LIMITED GUARANTEE
Depending on the place of purchase either the seller or LELIT guarantee this product for domestic use in specified
territories for a limited time from the date of purchase against defects caused by faulty workmanship and materials.
During this guarantee period either the seller or LELIT will repair, replace or refund any defective product at their sole
discretion. All legal warranty rights under applicable national legislation will be respected and will not be impaired by
any written guarantee.
For Australian consumers, this product comes with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other
reasonably foreseeable loss or damage.
You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure
does not amount to a major failure.
Important requirements as well as instructions on how to make a claim can be found on the LELIT website in the full
warranty terms and conditions.
Pag. 14
CAUSE
1. Coffee not suitable for machine
2. Improper grind
3. Too little coffee in filter
4. The filterholder has not been tightened
under the brewing group
1. The machine had not reached the proper
temperature
2. Filterholder not preheated
3. Cups not preheated
4. Pressure switch malfunction.
1. Coffee too coarsely ground
2. Not enough coffee in the filter
3. Coffee not pressed enough
4. Coffee/pod old or unsuitable
1. Filterholder not properly inserted
2. Too much coffee in the filter
3. Edge of the filterholder not clean
4. The douche seal is worn or damaged
1. Coffee too finely ground
2. Too much coffee in the filter
3. Coffee too firmly pressed
1. Obstructed the nozzle of the steam/hot
water wand
2. Too little water in tank
1. Too little water in tank
2. Steam switch on
3. Coffee too finely ground
4. Too much coffee in the filter
5. Coffee too firmly pressed
6. Shower plate obstructed
1. No electricity
2. The main cable is not properly plugged
in
3. The main cables damaged
1. Thermostat malfunction,
2. Heating element malfunction
SOLUTION
1. Change the coffee blend
2. Adjust the coffee grinding
3. Put more coffee in the filter
4. Tighten the filterholder more firmly
1. See section "Starting the Machine" and
"Making an Espresso Coffee"
2. Filterholder must be heated together with the
water – see section "Starting the Machine"
3. Properly heat the cups on the cup-warmer
4. Contact the nearest SERVICE CENTER
1. Use a finer grind
2. Put more coffee in the filter
3. Press coffee more firmly
4. Use different coffee/pod
1. Insert the filterholder correctly
2. Put less coffee in the filter
3. Clean the edge of the filterholder
4. Contact the nearest SERVICE CENTER
1. Use a coarser grind
2. Put less coffee in the filter
3. Press the coffee more gently
1. Clean the hole of the nozzle with a needle
2. See section "Starting the Machine"
1. Fill tank
2. Turn off the steam switch
3. Use a coarser grind
4. Put less coffee in the filter
5. Press the coffee more gently
6. Contact the nearest SERVICE CENTER
1. Restore electrical power
2. Plug the main cable in correctly
3. Contact the nearest SERVICE CENTER for a
replacement cable
1. Contact the nearest SERVICE CENTER
2. Contact the nearest SERVICE CENTER
English
Publicidad
