Publicidad
Idiomas disponibles
Idiomas disponibles
7 2 Using ARBPRO LD2 with Winch installed
Winch must be only used in combination with Stopper.
Set up (refer to picture n. 8):
open locking pin (1) by pulling the handle and twist
•
connect stopper plate (2) to the main frame by sliding into the guides
•
pull and twist the handle to release and let the pin lock into the frame
•
connect main frame (3) to the tree (see chapter 5)
•
insert the winch plate (4) with "top" sign up and lock it using the bar and pin
•
open stopper handle by pulling upwards
•
insert rope and close the stopper by pulling the handle down
•
with the stopper (5) locked the rope can only move down in the direction of the
•
winch
place the rope into the guides (6) before stopper and winch
•
wrap the rope on winch drum clockwise and fill the space on the drum. Last turn
•
must exit the drum (7) and locked in the self tailer
insert winch bar in the front hole (8) and the system is ready to pull
•
open side locking pins (9) and insert ONE rope guide only (10 or 11). In no cir-
•
cumstances winch operations can be performed with both guides mounted at
the same time. Looking at the device from the front, left guide (10) must be used
when the operator can move from front to left side of the device. Right guide
(11) when the operator can move from front do right side.
close locking pins and check rope guide is in correct position.
•
Fig 8
Pull:
Turn the handle clockwise to obtain a
13.8:1 pulling rate.
Turn the handle anticlockwise to obtain a
44.2:1 pulling rate
Attention!
Pulling winch handle is
strictly a one man opera-
tion. User must NEVER stay
in the rigging zone if any part of the
rigging system should fail
ENGLISH | 25
Publicidad
