Publicidad
Idiomas disponibles
Idiomas disponibles
II - Technical data
This tool is double insulated. There are two in dependent barriers of insulation to protect you from the possibility
of electric shock.
Voltage:....................................230–240V ~ 50Hz
Input
power:...............................................2000W
Noload
speed:.....................................4500min
Blade
diameter:......................................Ø305mm
Blade
teeth:..........................................24-120TCT
Blade
arbour:...........................................Ø16/ Ø25.4/ Ø30mm
Minimum blade
thickness:.......................2mm
Maximum blade
thickness:......................4mm
Mitre table
angles:...........................-45°/0°/+45°
Straight cut at 0° x 0°:
.............340mm x 102mm
Mitre cut at 45° x 0°:
................240mm x 102mm
Bevel cut at
0°x 45°(L):
.................................340mm x 55mm
0°x 45°(R):
.................................340mm x 40mm
Compound mitre cut at
45°(L)x
45°:..........................240mm x 55mm
45°(R)x
45°:..........................240mm x 40mm
Weight:.......................................................18.1 kg
NOISE AND VIBRATION DATA
Aweighted sound
pressure.....................99dB(A)
Aweighted sound
power.......................(112+3)dB(A)
Typical weighted
vibration.......................1.739m/s
III - Safety Instructions
WARNING. Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire
and/or serious personal injury. The term "power tool" in all of the warnings listed below refers to your
mains-operated (corded) power tool or battery-operated (cordless) power tool.
Safety rules for laser lights
The laser light/laser radiation used in the system is Class 2 with maximum 1mW and 650nm wavelengths.
These lasers do not normally present an optical hazard, although staring at the beam may cause flash
blindness.
WARNING.
Do not stare directly at the laser beam.
A hazard may exist if you deliberately stare into the beam, please observe all safety rules as follows;
The laser shall be used and maintained in accordance with the manufacturer s instructions.
Never aim the beam at any person or an object other than the workpiece.
The laser beam shall not be deliberately aimed at
personnel and shall be prevented from being directed towards the eye of a person for longer than 0.25s.
Always ensure the laser beam is aimed at a sturdy workpiece without reflective surfaces. I.e. wood or
rough coated surfaces are acceptable. Bright shiny reflective sheet steel or the like is not suitable for laser
use as the reflective surface could direct the beam back at the operator.
Do not change the laser light assembly with a different type. Repairs must be carried out by the laser
manufacturer or an authorised agent.
CAUTION.
Use of controls or adjustments or performance of procedures other than those specified herein
may result in hazardous radiation exposure.
General safety instructions
To use this tool properly, you must observe the safety regulations, the assembly instructions and the
-1
2
EN
3
Publicidad
