Publicidad
Idiomas disponibles
Idiomas disponibles
1) Push down on the operating handle (7) and pull the release knob (6) to disengage the saw arm (5). The
release knob (6) can be turned so that it is held in the retracted position.
Raise the saw arm (5) to its highest position.
2) Remove the hex screw that secures the blade bolt cover (14).
3) Pull the rotating blade guard (12) down then swing it up together with the blade bolt cover (14).
4) When the rotating blade guard (12) is positioned over the upper fixed blade guard (9) it is possible to access
the blade bolt.
5) Hold the rotating guard (12) up and press the spindle lock button (26). Rotate the blade until the spindle locks.
6) Use wrench (19) to remove the blade bolt. (Loosen in a clockwise direction as the blade screw has a left hand
thread).
7) Remove the outer blade washer and the blade.
Wipe a drop of oil onto the inner blade washer and the outer blade washer where they contact the blade.
Fit the new blade onto the spindle taking care that the inner blade washer sits behind the blade.
CAUTION. To ensure correct blade rotation, always install the blade with the blade teeth and the arrow printed on
the side of the blade pointing down. The direction of blade rotation is also stamped with an arrow on the upper
blade guard.
8) Replace the outer blade washer.
Depress the spindle lock button (26) and replace the blade bolt.
9) Use the blade wrench (19) to tighten the blade screw securely (anticlockwise).
Hold the rotating lower blade guard (12) and blade bolt cover (14) in position and tighten the fixing screw.
Check that the blade guard operates correctly and covers the blade as the saw arm is lowered.
Connect the saw to the power supply and run the blade to make certain that it is operating correctly.
2 MAINTENANCE
- Keep the tool's air vents unclogged and clean at all times.
- Regularly check to see if any dust or foreign matter has entered the grills near the motor and around the trigger
switch. Use a soft brush to remove any accumulated dust. Wear safety glasses to protect your eyes whilst
cleaning.
- Re-lubricate all moving parts at regular intervals.
- If the body of the tool needs cleaning, wipe it with a soft damp cloth. A mild detergent can be used but nothing
like alcohol, petrol or other cleaning agent.
- Never use caustic agents to clean plastic parts.
CAUTION. Water must never come into contact with the tool.
3 GENERAL INSPECTION
Regularly check that all the fixing screws are tight, particularly the outer flange. They may vibrate loose over time.
The supply cord of the tool and any extension cord used should be checked frequently for damage. If damaged,
have the cordset replaced by an authorised service facility. Replace the extension cord if necessary.
4. LUBRICATION
The grease in the gearbox will require replacement after extensive use of the tool. Please refer to an authorised
service agent to provide this service.
EN
12
Publicidad
