Publicidad
Idiomas disponibles
Idiomas disponibles
4
The dust bag (15) fits in the dust extractor port (27). For efficient operation, empty the dust bag when it is no
more than half full. This allows better air flow through the bag.
5. SETTING THE TABLE SQUARE WITH THE BLADE
Make sure that the electrical plug is removed from the power point
6 Push the saw arm (5) down to its lowest position and engage the release knob (6) to hold the saw arm in the
transport position.
7 Loosen the mitre lock (25).
8 Rotate the table (21) until the pointer is positioned at 0º.
9 Tighten the mitre lock (25).
10 Loosen the bevel lock (16) and set the saw arm (5) at 0º bevel (the blade at 90º to the mitre table). Tighten the
bevel lock (16).
11 Place a set square against the table (21) and the flat part of the blade.
NOTE. Make sure that the square contacts the flat part of the saw blade, not the teeth.
Rotate the blade by hand and check the blade-to-table alignment at several points.
The edge of the set square and the saw blade should be parallel.
12 If the saw blade angles away from the set square, adjust as follows:
Use a 13mm wrench or adjustable wrench to loosen the lock nut securing the 0° bevel adjustment screw (34).
Also, loosen the bevel lock (16).
Adjust the 0° bevel adjustment screw (34) with the wrench to bring the saw blade into alignment with the
square.
Loosen the screw holding the pointer of the bevel scale (17) and adjust the position of the pointer so that it
accurately indicates zero on the scale. Retighten the screw.
Retighten the bevel lock (16) and the lock nut securing the 0° bevel adjustment screw (34).
EN
8
Publicidad
