Starting The Table Saw; Protective Thermal Cut-Out; Saw Blade Braking - Fox F36-523 Manual De Instrucciones

DANGER: BEFORE SWITCHING ON THE MACHINE BE SURE THAT THERE IS NOT ANY
OBJECT ON THE WORKBENCH, THAT THE RIVING KNIFE IS CORRECTLY PLACED
AND THAT THE PROTECTIVE CAP AND THAT THE BLADE IS ASSEMBLED, IS NOT
DAMAGED AND THAT IT WORKS PERFECTLY.
To start the saw, press the ON green button
To stop the saw, push the OFF red button.
The switch of this machine is an undervoltage switch and
prevents the start of the machine in case of recovery of the
electrical energy after an interruption; so, you must press
the green button to re-start the saw after an interruption of
the electrical current.
The saw has a protective thermal cut-out (2) placed aside the switch, which stops the saw in case of overload,
in order to avoid to burn the motor.
When it starts, it sets off the switch and stops the saw. Then you must let the machine cool down some
minutes, then press the manual overload reset button and afterwards the green button of the switch to start
again the saw blade again. If it does not start, wait still some minutes and try again.
If the machine does not start, disconnect it from the socket and check the electric cable and the connections.
If the thermal cut-out often starts, it means you are pushing the blade too much or that you are using poor
quality or not sharpened saw blades.
This tool has a mechanical brake that stops the blade in less than 10 seconds since when you push the button.
Check the efficiency of the brake periodically, and if it does not work take the machine to an after sales service.
EN

STARTING THE TABLE SAW

PROTECTIVE THERMAL CUT-OUT

SAW BLADE BRAKING

44