Samsung NX58H9950W Serie Manual Del Usuario página 62

Problem
Surface burner components and
l caps are not assembled correctly
_ The burners do not burn
| | and level. |
evenly. ~ - Ea
| Surface burners are dirty. Clean surface urner
components. (See page 54.)
Wrong orifice is assernbled. | Check the burner orifice size and
contact your installer if you have
the wrong orifice (LP gas instead
of natural gas or natural gas
| instead of LP gas).
| Very large or yellow
| surface burner flames.
The oven door lock is turned on. | The display will show the Lock
| _ icon. Hold the oven door open
| Surface burners light Land press the START/SET button
| but oven burners do not | for 3 seconds. The oven will beep
light.
Gas Pressure Regulator shut off
¡Call a qualified service technician.
switch is in the off position. |
You have a function information — | Press the OFF/CLEAR button and
code. See the "Information codes" | restart the oven. If the problem
The oven control chart on page 67. | persists, disconnect all power to
beeps and displays.an | the range for at least 30 seconds
information code. | and then reconnect the power. If
| this does not solve the problem,
| call for service.
The oven burner air adjustment Call for a qualified service
shutters need to be adjusted. _ | technician.
Gas supply i is not properly | See the Instal ation Instructions
con nected or turned on. l that came with your range.
| Very large or yellow oven : |-— ee /
| burner flames. Wrong orifice is assembled. | Check the burner orifice size and
| | contact your installer if you have
l the wrong orifice (LP gas instead
l of natural gas or natural gas
| instead of LP gas).
| Oven temperature is too -| Oven thermostat needs | See page 45.
hot or-cold. adjustment.
English - 62