Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
If there is something wrong with your GOAT when working, you can consult the table below.
Please contact our Customer Service if the problems still exist.
Issue
Red Indicator Light on the Station
blinks.
The Indicator Light on the Station
becomes solid red.
GOAT stops within the working
area.
Cause
The Base connector is not correctly
connected to the Pile connector.
Station current and voltage are unstable.
There is something wrong with Camera Brush
motor.
There is something wrong with the Station
location or Navigation Beacon signal.
GOAT fails to dock with the Station.
GOAT fails to complete the Map Learning.
GOAT is trapped or suspended.
Solution
Make sure that the Base connector is correctly connected to
the Pile connector. If the problem still exists, please contact
Customer Service.
Please contact Customer Service.
1. Check if the Station or Navigation Beacon is moved. If it
happens, place it in the original position.
2. Check if Navigation Beacon runs out of battery. If it happens,
please replace the Dry Cell in it.
3. If the problem still exists, please remap.
1. Check if the Station is connected to the power outlet. If
correctly connected, the Indicator Light of the Station will be
solid blue.
2. Check if the Base connector is correctly connected with the
Pile connector.
3. Check if the Station re ective lm is blocked.
4. Check if there are obstacles near the Station. If it happens,
please remove the obstacles.
5. If the problem still exists, please contact Customer Service.
1. Check if there are obstacles or hollows on the lawn. If any,
please clear them away and restart Map Learning.
2. According to prompts in the App, adjust the Navigation
Beacon's position and remap.
1. Move GOAT to a safe place and then continue working.
2. If relocation failure occurs after moving, control/place GOAT
into the Station and restart it.
23 EN
Publicidad
