Publicidad
Idiomas disponibles
Idiomas disponibles
BEG 25.book Seite 9 Montag, 23. Januar 2012 9:31 09
Maintenance and Cleaning
Before any work on the machine itself, pull the mains
plug.
Always keep the machine clean.
Never clean the unit with a steam spray.
If the machine should fail despite the care taken in man-
ufacturing and testing, repair should be carried out by
a Würth Master-Service agent.
What is to be done in case of a malfunction?
Problem
The filling pump does not
draw or build up pressure
No power to the unit.
Disposal
Power tools, accessories and packaging should be sort-
ed for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into house-
hold waste!
According to the European Directive
2002/96/EC on waste electrical and elec-
tronic equipment and its incorporation into
national law, power tools that are no longer suitable for
use must be separately collected and sent for recovery
in an environmental-friendly manner.
Warranty
For this Würth tool, we provide a warranty in accord-
ance with statutory/country-specific regulations from
the date of purchase (proof of purchase by invoice or
delivery note). Damage that has occurred will be cor-
rected by replacement or repair.
Damage caused by normal wear, overloading or im-
proper handling is excluded from the warranty.
Claims can be accepted only when the machine is pre-
sented undisassembled to a Würth branch office, your
Würth sales representative or a customer service agent
for Würth pessure air and power tools.
For all correspondence and spare parts orders, always
include the article number on the type plate of the ma-
chine.
For the current spare parts list of this machine, log into
the Internet under "http://www.wuerth.com/
partsmanager" or ask for a copy at your nearest Würth
branch office.
Cause
The fluid container is empty.
Suction hose is kinked.
Air in the hose.
The shut-off valve 2 is in the «CLOSE»
position.
Fuse defective.
We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents:
EN 12100-2010, EN 60204-1:2006 according to the
provisions of the Directives 2006/42/EC, Annex II,
No. 1, paragraph A.
Technical file at:
Adolf Würth GmbH & Co. KG, Abt. PFW
74650 Künzelsau
T. Klenk
Gerneral Manager
Künzelsau: 12.12.2011
Subject to change without notice
Corrective Action
Replace the container.
Remove kinks from the hose or replace,
if defective.
Vent the unit as for initial operation.
Shut-off valve 2 to the «OPEN» posi-
tion.
Replace the fuse 5.
Declaration of conformity
A. Kräutle
Gerneral Manager
9
Publicidad
