Publicidad
Idiomas disponibles
Idiomas disponibles
6 Preparing the Mowing Area and Robot Mower for Operation
A
5
B
Up to three starting points (5) can be specified
on a guide wire (4). The robotic mower can move
specifically to the respective starting point and
start mowing from there.
The mowing area can be divided into several
zones (example: A and B) by the guide wire (4).
The zones are defined by a starting point (5).
The robotic mower can be directed from the
selected starting point to the left or right into the
desired zone. The robotic mower can then mow
specifically in the selected zone. The starting
points and zones are managed in the
®
MY iMOW
app and can be taking into account
in the mowing plan.
If there is a confined section (6) in the mowing
area, the robotic mower navigates the confined
area, provided that a particular minimum width is
maintained between the perimeter wires. If the
minimum distance cannot be maintained, a guide
wire (7) must be routed through the confined
section (6). The guide wire (7) then guides the
robotic mower directly through the confined sec‐
tion (6) to a starting point (8). From the starting
point (8), the robotic mower can mow the mow‐
ing area behind the confined section (6). The fre‐
quency at which the robotic mower returns to the
starting point (8) can be managed by the
®
MY iMOW
app and taken into account in the
mowing plan.
0458-012-9801-A
4
6
7
8
6
Preparing the Mowing Area
and Robot Mower for Oper‐
ation
6.1
Planning and preparing mow‐
ing areas
Plan and prepare the mowing area prior to com‐
missioning the robot mower. This enables a
robust installation and smooth operation and
eliminates potential sources of faults.
Planning mowing surfaces
► Familiarize yourself with the descriptions
about the docking station and wire routing in
the following sections.
► Transfer the information to your own garden:
– Outline of the mowing area
– Position of the docking station
– Routing of the perimeter wire (note descri‐
bed distances to the edges and wire routing
cases)
– Routing of the guide wire(s) (at least one,
maximum of three)
Preparing mowing areas
► Remove any objects lying around.
► Remove metals, magnetic materials and mate‐
rials that conduct electricity as well as old
perimeter wires.
► Mow lawns with a lawn mower to the cutting
height that will later be set for the operation of
the robot mower. The default setting for the
cutting height on the robot mower is a = 6 cm.
► Level out holes and rough, uneven patches.
► Where ground is hard and dry, slightly moisten
the mowing area to make driving the anchor‐
ing stakes easier.
English
a
61
Publicidad
