Kohler Veil K-5402-0 Instrucciones De Instalación página 8

5. Install the Water Supply and Plaster Guards
1/2 NPT
Adapter
NOTE: The tank valve inlet uses G1/2 threads. If desired, install a 1/2 NPT adapter to the tank valve inlet.
Verify that the rubber seal is inserted into the 1/2 NPT adapter, if used.
Install a 1/2 NPT adapter, if desired, and tighten securely.
Install and connect the water supply line.
Install the Plaster Guards
NOTICE: Remaining parts are required for the bowl installation. Retain these parts.
Insert the plaster guards into the carrier inlet and outlet holes.
Place the actuator frame locking pins and bowl nut, washer, and cap set inside the flush shield to retain them until the
finished wall is complete.
Align the flush shield over the flush valve opening. Snap the flush shield into place.
1247365-2-C
Water Supply
Outlet
Hole
8
Shield
Inlet Hole
Plaster Guard
Kohler Co.