Publicidad
Idiomas disponibles
Idiomas disponibles
6. Install the Finished Wall
CAUTION: Risk of product damage. Do not puncture the water tank with fasteners. Use the template provided
inside the box lid to determine fastener locations for securing the finished wall. Hang this template on the flush
shield to identify the tank location.
IMPORTANT! Gypsum board may compromise the load strength of the toilet installation. Kohler Co. recommends the
use of cement board or tile backer board for the wallboard backing.
NOTE: The total wall thickness should not exceed 2-3/4" (70 mm).
Hang the provided template on the flush shield to identify the tank location.
Install cement board.
Install the finished wall.
Verify that the electrical wires and power cords are accessible through the cutout on the side of the drain pipe.
Use a sharp utility knife to carefully trim the flush shield even with the finished wall.
NOTICE: Retrieve and retain the actuator frame locking pins and bowl nut, washer, and cap set from inside the flush
shield.
Discard the trimmed off portion of the shield.
Kohler Co.
Finished Wall
36"
(914 mm)
Min
9
Flush Shield
Front View
16" (406 mm)
Min
Cords
1247365-2-C
Publicidad
