HTW FP-27AA Manual De Usuario E Instalacion página 19

Note
The cooling-only unit doesn't have heat mode.
[SLEEP] button
10.
Press SLEEP button, then display screen shows " SLEEP" ,the sleeping function of the air
conditioner is activated.
[SWING] button
11.
Press this button, the horizontal wind direction vanes can swing automatically, when you have the
desired vertical wind direction, press it again, the horizontal wind direction vanes will be stopped
at the situation of your choice.
[HEALTH] button
12.
Press this button, you can turn on or off the health function.
13. [FUNGUSPROOF] button
This A/Chas special dry and anti-mold function which has "yes" or "no" two selections. This
function is controlled by the remote controller under cooling, dry and auto (cooling
modes, the horizontal wind guiding bars are at the initial position for cooling.
The A/C runs under heating mode(the cooling only A/C only runs under fan mode), the interna! fan
runs for three minutes with weak wind befo re stop. The purpose of this function is to dry the
inside of the evaporator and to prevent the evaporator from going mouldy due to water deposition
and thus dispersing strange smell.
Note:
This function has not been set in the factory. You may freely set and cancel this function. The
setting method is: under "off" status of the A/C and the re mote controller, point the remote
controller toward the A/C and continuously press "FUNGUSPROOF" pushbutton for one time,the
buzzer keep beeping five times again after five times beep, indicating that this function is ready. In
case this function has been set, unless the whole A/C is powered off or the function is manually
cancelled, the A/C then has this function as default;
To cancel the function: 1. Power off the whole A/C; 2. Under "off" status of the A/C and the re
mote controller, point the re mote controller toward the A/C and continuously press
"FUNGUSPROOF" pushbutton for one time, the buzzer keep beeping three times again after five
times beep, indicating that this function has been cancelled;
When this function is on, it is suggested not to restart the A/C before it is completely stop;
This function will not run in case of time stop or sleep stop.
and dry)