Publicidad
Idiomas disponibles
Idiomas disponibles
Instalación
Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be
preserved around the hole. Be sure the thickness of the work surface is at
least 30mm. Please select heat-resistant and insulated work surface material
(Wood and similar fibrous or hygroscopic material shall not be used as work
surface material unless impregnated) to avoid the electrical shock and larger
deformation caused by the heat radiation from the hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner
surfaces of the worktop should be at least 3mm.
L(mm)
W(mm)
590
520
Under any circumstances, make sure the Induction cooker hob is well ventilated
and the air inlet and outlet are not blocked. Ensure the induction cooker hob is in
good work state. As shown below
Note: The safety distance between the hotplate and the cupboard above
the hotplate should be at least 760 mm.
H(mm)
D(mm)
62
58
EN-34
A(mm)
B(mm) X (mm)
560+4
490+4
+1
+1
F
Min. 3mm
F(mm)
50 min.
3 min.
Publicidad
