Menu Settings; Manual Temperature Compensation - Mettler Toledo SevenGo Duo SG23 Instrucciones De Manejo

Menu settings

6 Menu settings
The following settings are possible in the menu:
●
Set MTC temperature
●
Set reference temperature
●
Set temperature correction coefficient
●
Set TDS factor
●
Select measurement modes for alternating display

6.1 Manual temperature compensation

If the meter does not detect a temperature probe, it automatically switches to the manual temperature
com pen sa tion mode and MTC appears. This setting only applies to mV/pH measurements.
a) Press
b) Press
c) Press READ to confirm the setting.
d) Press EXIT to return to the measurement screen.
The default setting is 25 °C. For better accuracy, we recommend the use of either a built-in or a separate
tem per a ture probe. If a temperature probe is used, ATC and the sample temperature are displayed. The
meter accepts NTC 30 kΩ temperature sensors.
6.2 Selecting the reference temperature
a) Press
b) Press READ.
c) Press
d) Press READ to confirm your selection.
e) Press EXIT to return to the measurement screen.
6.3 Setting the temperature correction coefficient
a) Press
b) Press READ.
c) Press READ.
d) Press
e) Press READ to confirm the setting.
Press EXIT to return to the measurement screen.
f)
6.4 Setting the TDS factor
a) Press
14
.
The MTC temperature blinks.
or to increase or decrease the value of the temperature for the sample.
.
The MTC temperature blinks.
and the current reference temperature appear.
or to toggle between 25° C and 20° C.
.
The MTC temperature blinks.
appears.
and the current temperature coefficient appear.
or to increase or decrease the value.
.
The MTC temperature blinks.
pH/conductivity meter SG23