Etac Molift Raiser Pro Manual De Usuario página 6

Molift Raiser Pro / BM43099 Rev I / www.etac.com
Mounting pipes to base plate
1
1. Place the base plate on an even surface and lock brakes. Insert
pipe with holes facing towards center of plate. Pipe with label must
be at the right, standing on the assistant side. Mount the knob so
it is perpendicular to the pipe and angled slightly up in relation to
the horizontal.
2
2. Tighten knob firmly by turning
knob clockwise.
Make sure that knob are Properly fastened.
Loose knobs can make the pipes wobbly and
the Molift Raiser Pro unsafe to use.
Mounting leg support
The knee cushions are adjusted individually. The leg support has 7
step adjustment from 0,3 to 0,51 meters. Follow these two steps
when mounting the leg support:
1
1. Pull release wire and slide the leg
support on pipes, cushion facing
user side.
2
"Click"
2. Release wire and let
the leg support settle in
desired position.
6
Mounting handle
1
1. Slide the handle on pipe so holes
on pipe maching holes on handle.
Innsert unbraco screws and tighten
with allen key.
Checklist after assembly
Don`t start using Molift Raiser Pro before
completing the checklist after assembly.
Use this checklist to verify that the Molift Raiser Pro is Properly
installed and can operate correctly and safely before use. See
assembly information on the previous page for details.
• Make sure that the leg support is mounted correctly.
• Make sure that both knobs between outer pipes and
base plate are mounted correctly and Properly tightened
• Make sure that the handle is mounted correctly.
• Make sure Molift Raiser Pro moves freely.
• Make sure brake works.
Adjusting leg support height
1
1. Pull wire on the back side
of cushions. Move leg sup-
port up or down to desired
height.
2
2. Make sure unbraco
screws are pointing
towards assistant side.
51
48
45
42
39
"Click"
36
33
30
2. When correct knee support
height is obtained, release wire
and let the leg support settle in
desired height. You will hear the
leg support "click" in place and
the red wire is straight.
The knee support height can
be read from the scale on the
pipe. The number above the leg
support bracket referes to the
correct height.
2