Publicidad
Idiomas disponibles
Idiomas disponibles
How to Use
EN
Filling the Clean Water Tank
Press the Clean Water Tank release button and pull the tank outwards to remove it.
Remove the cover of the Clean Water Tank and fill the tank with clean water. Install the
Clean Water Tank and ensure it clicks into place.
Note:
• For better cleaning performance, it is recommended to add 10ml detergent with the bottle cap into
the full Clean Water Tank, then shake gently and evenly for use.
• Do not add any liquids other than the officially-approved cleaner. The cleaner can be available on
the official online store.
Starting Cleaning
Gently step on the brush cover and recline the appliance backwards. Press the power
switch
to start operating.
＜140°
Note:
• Do not vacuum any foamy liquids.
• If the appliance is in the upright position while working, the current task will be suspended.
• The appliance is suitable for cleaning floors, marble, tiles and other hard surfaces.
• Please press the brush against the floor when using. Do not recline the appliance backwards more
than 140° to prevent the appliance from leaking water.
• When the appliance is in operation, do not lift it off the ground, tilt it or lay it flat. Doing so may
cause the used water to flow into the motor.
9
9
How to Use
Switching Modes
The appliance is powered on in auto mode by default, you can switch to the ultra mode-
the suction mode-the turbo mode as needed.
Self-Cleaning with Hot Water
1. Place the appliance back onto the base while you finish cleaning. Ensure that the
water in the Clean Water Tank is sufficient for self-cleaning.
2. Briefly press the self-cleaning button
cleaning with hot water. Switch between self-cleaning modes according to the voice
prompts.
3. Please empty the Used Water Tank after self-cleaning is completed and drying mode
has been engaged. Press the button
Note:
• The self-cleaning function can be enabled only when the appliance is being charged and the
battery level is more than 15%.
• Do not touch the brush roller, hot water and the heating module on the charging base during the
self-cleaning process.
Empty the Used Water Tank
Press the used water tank release button to take out the tank. Pull up the tank cover and
pour out the used water. Reinstall the tank cover and the tank before use.
2
1
on the top of the handle to start self-
to exit the drying mode.
3
EN
4
10
10
Publicidad
