Publicidad
O
STORAGE
immediately prepare your snow thrower for storage at the end of the season or if the unit will not be used for 30 days or more.
WARNING:
Never store the snow thrower
with gasoline
in the tank inside a building
where fumes may reach an
_open
flame, spark or pilot light as on a furnace,
heater,
dryer or gas appliance,
engine
water
clothes
Allow the
to
cool before storing
in any enclosure.
Snow thrower
When snow thrower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean,
dry area.
1.
Clean entire snow thrower (See "CLEANING"
in the Maintenance section of this manual).
2.
inspect and replace belts, if necessary (See "TO REPLACE BELTS" in the Service and Adjustments section of this manu-
al).
3.
Lubricate as shown in the Maintenance section of this manual.
4.
Be sure that all nuts, bolts, screws, and pins are securely fastened, inspect moving parts and guards for damage, breakage
and wear. Replace if necessary.
5.
Touch up all rusted or chipped paint surfaces; sand lightly before painting.
ENGINE
See engine manual.
Fuel system
1.
Drain the fuel tank.
2.
Start the engine and let it run until the fuel lines and carburetor are empty.
Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.
Use fresh fuel next season.
Engine
oil
Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual).
Cylinder
1.
Remove spark plug.
2.
Pour one ounce (29 mi) of oil through spark plug hole into cylinder.
3.
Pull recoil starter handle slowly a few times to distribute oil.
4.
Replace with new spark plug.
OTHER
•
Remove safety ignition key; store in a safe place.
•
Do not store gasoline from one season to another.
•
Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.
•
if possible, store your snow thrower indoors and cover it to protect it from dust and dirt.
•
Cover your snow thrower with a suitable protective cover that does not retain moisture. Do not use plastic. Plastic cannot
breathe, which allows condensation
to form and will cause your snow thrower to rust.
IMPORTANT:
Never cover snow thrower while engine/exhaust
area is still warm.
LAGERUNG
Machen Sie Ihre Schneefr&se sofort gen Ende der Saison lagerfertig, oder wenn Sie das Ger&t 30 Tage oder I&nger nicht be-
nutzen werden.
WARNUNG:
Lagern Sie die Schneefr&se bei gef_lltem
Benzintank hie in einem Geb_iude, in dem die Benzind_mpfe
_kan
eine offene Flamme, eine ZLindvorrichtung oder ZL_ndflamme wie an einem Gasherd, ein Heil}wasserger&t,
einen
W&schetrockner
oder ein gasbetriebenes
Ger&t gelangen k6nnten.
Lassen Sie den Motor zun_chst abk_hlen,
bevor
Sie das Ger_t in einem geschlossenen
Raum lagern.
Schneefr se
Soil die Schneefr&se 0bet einen I&ngeren Zeitraum gelagert werden, so reinigen Sie sie sorgf<igst.
Entfernen Sie jegtichen
Schmutz, Schmier6t, Bl&tter, usw. Lagern Sie das Ger&t in einem sauberen, trockenen Bereich.
54
Publicidad
