Greencut GTC300XE Guía De Mantenimiento página 52

IT - GTC300XE
FUNZIONAMIENTO
PRIMA DELL'AVVIAMENTO DEL MOTORE
HITCH BOX USE
Install the hitch accessory into the hitch box with a hitch pin.
FRONT WHEEL
Move the rudder on the road by the front wheel; Raise the handlebar to the ground at the front
of the wheel. When using the tiller in the field, move the wheel up by replacing the locking pin.
MANAGEMENT TIPS
Adjust the handlebar height to a comfortable position (waist height for normal tilling).
Press down on the handlebars.
If the machine does not advance, move it from side to side.
Turn: The proper method for negotiating a turn during a tillage operation is to lower the
handlebars to bring the center of gravity rearward and then make the turn, which will allow you
to perform the turn with relative ease.
NORMAL OPERATION ANGLE
Lower the handle slightly so that the front of the machine is raised 6 to 8°.
To get the most benefit from the cultivator, try to hold the machine at the angle shown while
tilling the soil.
PRECAUTIONS:
Do not use the cultivator with a rotor whose diameter exceeds 300 mm.
Operating it on slopes could cause it to fall.
Allowing anyone to operate without proper instructions may result in injury.
Wear full coverage shoes.
Do not use the machine at night.
Be sure to use two people to transport it without using a carrier.
In case of emergency, turn the engine switch to "OFF".
52