Publicidad
Idiomas disponibles
Idiomas disponibles
Before Use
EN
1. Remove the Protections
④
②
①
③
2. Install the Side Brush and the Mop Assembly
Side Brush
Clip
Note: Install the side brush until it clicks into place.
10
3. Connect to an Electrical Outlet
Place the base station in a location that is as open as possible with a good Wi-
Fi signal. Then insert the power cord into the base station and plug it into the
socket.
I:ON
Firmly insert the power
O:OFF
cord upwards until the
indicator turns on.
4. Place the Base Station and Install the Base Station Ramp
Extension Plate
Place the Base Station and remove any objects that are closer than 1.5 m
from the front and 5cm from either side of the base station. Then install the
ramp extension plate down to the base station.
＞5cm
＞5cm
＞1.5m
Note: To prevent water stains from wetting wood floors or carpets, placing
the base station on tile floors or marble floors is recommended.
Before Use
5. Place the Robot
Press and hold the
button on the robot for 3 seconds to turn it on. Place
the robot onto the base station with the mop assembly facing toward
the washboard. Then you will hear a voice notification when the robot
successfully connects to the base station. After the robot is fully charged,
the status indicators on the robot and the base station will remain lit for 10
minutes and will then dim.
Note: It is recommended to fully charge the robot before its first use. When
the robot cannot be turned on after the battery is depleted, manually
connect the robot with the station to charge it.
6. Add the Cleaning Solution
(1) Remove the dust tank cover and pull out the auto-detergent
compartment.
(2) Open the upper lid of the compartment and add the cleaning solution.
(3) Close the lid of the compartment, put it back it into the base station, and
then reinstall the dust tank cover. The cleaning solution will be added into
the clean water tank automatically while working.
②
①
②
Note:
①
·Do not add any liquid other than the officially-approved cleaning solution
to help prevent malfunction.
·Install the auto-detergent compartment until it clicks into place.
7. Add Water to the Clean Water Tank
Take out the clean water tank from the base station and add clean water into
the tank. Then install it back into the base station.
Note: Do not add hot water into the water tank, as this may cause the tank
to become deformed.
EN
11
Publicidad
