Publicidad
Idiomas disponibles
Idiomas disponibles
Filter cartridge change indicator light (7)
E
• A red light will come on to indicate that the filter cartridge
needs to be changed (E).
beep
• Remember to drain the device at the same time.
F
Changing the filter cartridge
• Lift up the lid of the water tank (4) and remove it by pulling
on the lid. Empty the water and remove the filter cartridge
(F).
• Insert a new filter cartridge (12) (available on our online
store or from an official Laurastar retailer) and refill the
G
water tank (G).
• Finally, confirm the change by pressing the cartridge
change switch.
Draining the device
H
To maintain the effectiveness of your device and to avoid
traces of limescale, you must drain it each time you change
the filter cartridge.
ADVICE: Drain your device every 10 hours of use or
once a month.
I
When draining the device, refer to the following
instructions:
• Ensure that the power plug (10) has been removed from
the socket, the water tank (4) has been removed and the
DMS Steamer (2) has been placed to the side.
• Shake the device (1) firmly in circular movements and
place it over a sink (H).
J
• Lift the protective tab (9) on the drain cap and unscrew it
with a coin (I).
• Drain all the water from the device (J).
• Retighten the drain cap, replace the protective flap and fill
up the tank with water.
• You can turn your device back on.
- 11 -
PROBLEMS AND SOLUTIONS
Before calling the Laurastar Customer Service department, please check the following
points:
Symptom
Makes a buzzing noise when steam
is emitted from the aluminium
Generator vibration (1).
soleplate.
Makes a crackling noise when the
The appliance has been set to
appliance is switched on.
heat up.
The white indicator light flashes
The water has been reheated.
during disinfection.
The aluminium soleplate no longer
• The reservoir (4) is empty.
emits steam. The pressure has
• The appliance is switched off.
fallen.
• The plug (10) is disconnected.
The light remains red when the
The reservoir has not been correctly
reservoir is full.
replaced.
• The DMS Steamer is not ready.
• The appliance has not been
The soleplate drips.
drained recently.
• The reservoir has been rinsed
with a product other than water.
The aluminium soleplate does not
• The plug (10) is disconnected.
heat up.
• The On/Off switch (5) is off.
Return to the Customer Service department
Switch off the appliance and disconnect the plug. Locate your purchase contract,
invoice or receipt. Telephone the Customer Service department and follow the
instructions given.
Likely cause
Remedy
This noise is normal for a new
appliance, it will disappear in the
course of use.
This noise is normal when the
appliance is heating up.
The appliance is working normally.
• Fill the reservoir with water.
• Press the appliance's On/Off
switch (5).
• Connect the plug.
Remove the reservoir and replace
it correctly in the base, with the
cover open.
• Wait until the white indicator
light on the On/Off switch (5) stops
flashing.
• Drain the appliance.
• Call the Customer Service
department.
• Connect the plug.
• Switch on the appliance.
- 12 -
EN
Publicidad
