Novonova NV-1026 Manual De Instrucciones página 12

1.-
Regularly remove dust to keep parts clean. It is necessary to clean both sides of the running machine,
which will reduce the accumulation of impurities under the running machine.
2.-
After each use of the running machine, clean the instrument and other parts of the sweat stains and debris
with clean towels and damp cloth. Be careful not to splash water on the electrical components and under
the running belt.
Do not use sandpaper or solvent to clean the running machine, the controller part can not be
3.-
Keep your treadmill in a clean, dry environment. Make sure the power is off and the plug is unplugged.
4.-
To facilitate movement, the running machine is equipped with wheels. Make sure to disconnect the power
supply and fold the fuselage before moving.
5.-
Regularly check and lock all parts of the running machine, and the damaged parts must be replaced
immediately.
6.-
In order to maintain and prolong the life of the running machine, it is recommended that you rest the
running machine for 10 minutes after 30 minutes of continuous use.
8.-
LUBRICATING OIL
The treadmill motor requires minimal belt lubrication care, which, if not followed, can lead to serious
problems. Lack of lubrication can cause various malfunctions in the machines.
Treadmills come lubricated from the factory, but during storage time, the lubricant can dry out, and it is
advisable to lubricate before the first use.
• REGULAR USE: For those who use the treadmill regularly (about 3 to 7 times a week), it is
recommended to lubricate the machine approximately every 3 months or every 130 kilometers,
depending on the manufacturer's guidance.
• LIGHT USE: If you use the treadmill less frequently, you can lubricate it less often, such as every six
months.
• SIGNS OF NEED: In addition to regular frequency, you should lubricate your treadmill if you notice
that the belt begins to stick, or if the machine makes unusual noises during use, as these can be signs
of excessive friction.
The lubrication point is located in the middle of the lower surface of the running belt. When adding
lubricant, please inject it into the center of the running board, then lower the belt, press the area by hand
to spread the lubricant, and rotate the belt to ensure it is applied evenly.
ENGLISH
12.
REMIND:
directly exposed to the sun or damp, to avoid damage.