Novonova NV-1026 Manual De Instrucciones página 13

• The refueling location is in the center of the treadmill
belt.
• Trim the nozzle of the oil bottle to create a small
opening, not too large, but enough to allow for
injection.
• Lift the treadmill belt to extend the nozzle to the
underside of the belt and inject oil into the center of
the treadmill. Lower the belt, press the area where
the oil has been injected, rotate the belt, and ensure
that the oil is evenly distributed across the board.
• After oiling, wait a minute for the oil to spread evenly
before starting the treadmill.
9.- RUNNING BELT ADJUSTMENT METHOD
RUNNING BELT TIGHTNESS ADJUSTMENT
If the running belt is too loose, please insert the
hexagon spanner gifted randomly into the
adjusting hole of the left foot guard of the running
machine.
Rotate the wrench clockwise for 1/4 turns, and
then adjust the right leg guard clockwise for 1/4
turns. Be careful to adjust the left and right side
synchronously so as to tighten the belt and keep it
from deviating from the center.
If the running belt is too tight, the left and right
sides adjustment should be synchronized and
counterclockwise.
LEFT BOLT
The running belt can not be adjusted too tightly. This will break the running belt, increase the pressure on
the front / rear rotary drum, damage the roller bearings, produce abnormal sounds or other problems.
ENGLISH
13.
It is appropriate to adjust to running belt without skidding.
NOTE:
RIGHT BOLT