Changing The Contact Points; Checking The Device Operates Properly - Num'axes Canicalm First Manual De Instrucciones

Idiomas disponibles

Retighten the battery cover using a coin. A beep sound is emitted indicating the collar is ready

for use. If you do not hear any beep sound when retightening the battery cover, remove the

battery immediately from its housing. Check the polarity before trying again.

NOTE : when changing the battery, there can remain some power in your collar. In that case, the collar

does not emit any beep sound when you retighten the battery cover after inserting the battery. To

make sure it operates correctly and that the battery is correctly installed, see § Checking the device

operates properly.

Due to greater use during your dog's training, the first battery may not last as long as replacement

batteries.

Changing the contact points



Two different series of contact points are supplied. The length of the contact points must be sufficient

to have proper contact with the dog's skin, enabling the device to operate correctly (proper barking

detection and correct transmission of the stimulations).

If you have a long-haired dog and the short contact points fitted to the collar in the factory are

inadequate, remove and replace them with the long ones supplied with the kit.

Carefully tighten them manually (do not use a key).



You can check that your collar is functioning properly at any time using the following procedure:

Before doing so, make sure the collar is turned Off (battery removed from its housing).

Fix each wire of the neon test lamp under each contact point (unscrewing them lightly and

retightening them so as to pinch the test lamp wires under the contact points).

Turn On the collar (battery in place - Warning : after activating the collar, it remains in stand-

by for 30 seconds).

Make a streaked object (ex. knife with teeth and isolated sleeve) slide on the bark detection

contact point (ref. Diagram 1).

The collar should emit beep sounds and the test lamp should light.

Before disconnecting the test lamp, make sure the collar is turned Off (battery removed from its housing).

Gb - 15

Tabla de Contenido