Create Wind Calm Patio Manual De Instrucciones página 13

Connect the cables from the connection board to those from the LED panel.The LED panel is
magnetized so it attaches to the connection board by simply putting both pieces together.
Note: While installing or removing the LED board, be careful not to touch the insulating tabs.
Do not overtighten the screws or thread them too quickly as this could cause damage to the
insulating tabs.
Then attach the LED board decorative screen by screwing it onto the motor connection panel.
C H ECK IN STAL L AT I O N
• Check the correct operation of the ceiling fan, checking that no strange movement or mis-
alignment is observed in any part of the fan.
• If you notice any type of hum/vibration, you can proceed to adjust the blades with the bal-
ancing kit.
• This kit has self-adhesive counterweights and "u" shaped clips.
• Turn off the ceiling fan.
• You can put the clip in the center of any blade and check to see if the vibration decreases.
• Turn on the fan and check. If no change is seen, turn off the fan and add another clip on
another blade or use the adhesive weights.
* Only for models with Wi-Fi
The CREATE app is available for both Android and iOS (search for the app on Google Play
or App Store or scan the QR code below). There may be additional costs depending on the
provider.
This device is used through your home network. As an essential requirement, you must have
a Wi-Fi network always connected to your 2.4 Gh router and the free CREATE application.
(Internet providers currently offer both 5Gh and 2.4Gh simultaneously.)
We recommend that you disconnect the appliance from the mains when you are away from
home to prevent it from accidentally starting up while you are away.
iPhone
CONNECTION TO THE APP
Android
E NGLI SH
13