MIRKA 1230 L Instrucciones De Manejo página 72

en (original)
To protect the electronics and motor, the machine is equipped with a motor cooling filter. Clean the motor cooling filter
regularly.
For areas with a high concentration of fine dust in the surrounding air it is recommended to equip the machine with an
optional motor cooling filter PET to prevent dust from settling inside the air channels and motor. Contact your local sales
representative.
Caution: If the motor cooling filter is clogged by dust the overload protection switch in the motor may be
tripped. If this happens, switch off the machine, clean the motor cooling filter and allow machine to cool for
approx. 5 minutes.
Wet pick-up
Caution: The machine is equipped with a water level limit system which shuts off the machine when the
maximum liquid level is reached. When this occurs, switch off the machine. Disconnect the machine from the
socket and empty the container. Never pick up liquids without the water level limit system and filter in place.
Picking up liquids
Do not pick up flammable liquids.
Before liquids are picked up, always remove the filter bag/disposal bag and check that the water level limit works
properly.
If foam appears, stop work immediately and empty the container.
Clean the water level limiting device regularly and check for signs of damage.
Dry the wet filter and interor parts of the liquid container before storage.
Before emptying the container, unplug the machine. Disconnect the hose from the inlet by pulling out the hose. Release
the container clamps by pulling them outwards so that the motor top is released. Lift the motor top off the container.
Always empty and clean the container and water level limit system after picking up liquids.
Empty by tilting the container backwards or sideways and pour the liquid into a floor drain or similar. Refit the motor top
on the container. Secure the motor top with the container clamps. Sudden movements can accidentally trigger the water
level limiting device. Should this happen; turn off the machine and wait for 3 seconds to reset the device.
Continue to operate the machine afterwards.
Dry pick-up
Caution: Picking up environmentally hazardous materials. Materials picked up can present a hazard to the
environment.
Dispose of the dirt in accordance with legal regulations.
Unplug the machine before emptying after dry pick-up. Release the container clamps by pulling them outwards so that
the motor top is released. Lift the motor top off the container.
Filter: Check the filters. To clean the filter you can shake, brush or wash it. Wait until the filter is dry before re-starting
dust pick-up.
Dust bag: Check bag to ensure the fill factor. Replace dust bag if necessary. Remove the old bag. The new bag is fitted
by passing the cardboard piece with the rubber membrane through the vacuum inlet. Make sure that the rubber membrane
passes the raised part of the vacuum inlet.
After emptying: Close motor top on the container and secure the motor top with the container clamps. Never pick up
dry material without having a filter fitted in the machine. The suction efficiency of the machine depends on the size and
quality of the filter and dust bag. You should therefore only use an original filter and dust bags.
After using the machine
Unplug the machine from the socket when the machine is not in use. Wind up the cord starting from the machine. The
power cord can be wound up around the motor top or the container, or hung from the hook provided, or some other
fastener.
Transport
Before transporting the machine, close all the container clamps.
Do not tilt the machine if there are liquids in the container.
Do not use a crane hook to lift the machine.
Do not lift the machine by the trolley handle
72
Mirka® Dust Extractor 1230 L - PC & AFC