Publicidad
Idiomas disponibles
Idiomas disponibles
2.1 WASHING PHASES
2.1.a Machine OFF
When the machine is switched OFF the display will
read "OFF":
EN
2.1.b Switching on and preparing the machine
To switch the machine on, press the "Q1" button. The
LED representing the last cycle selected wil
When switched on, the
paration procedure begins.
Only for BT models, the rinse pump starts and then the
drain pump.
At the end of this first phase, the filling of the boiler
and subsequent heating begin. Once the temperature
is reached, the tank is loaded simultaneously with the
detergent dispenser for the set time.
The display will give the tank temperature;
It is advisable, when first switching on, to wait until
the display reads 55°C.
Once the temperature is reached, the tank is loaded
simultaneously with the detergent dispenser for the
set time.
While the machine is filling up, the START key will turn
RED and "F2" will appear on the right side of the display.
When the set tank temperature is reached, the START
key lights up STEADY GREEN.
WASHING OPERATION
The use of hand-washing products is to be avoided
as they could produce foam inside the machine.
IPlace the basket of items to be washed inside the
machine, having first removed any solid waste.
16
ATTENTION
LC2
LED flashes and the pre-
IMPORTANT
ATTENTION
2.1.c Cycle selection
Press the "S9" or CYCLE
button to select the washing cycle required from the 4
different cycles available
(LC1 - LC2 - LC3 - LC4
(SHORT, MEDIUM, LONG, INTENSIVE) and specifi-
cally:
1: SHORT CYCLE = * 152 sec.
LC
2: MEDIUM CYCLE = * 147 sec.
LC
LC
3: LONG CYCLE
4: INTENSIVE CYCLE = * 449 sec.
LC
* without rinsing
2.1.d STARTING UP THE WASHING CYCLE
2.1.d.1 STARTING UP THE WASHING CYCLE
MANUALLY
To start up the cycle MANUALLY, press and release the
"S3" button (the cycle start when the button is released
and not when the button is pressed).
The START key turns BLUE during the entire duration
of the wash cycle.
The LEDs of the display will light on in sequence and
the message shown on the display will blink (indicating
that the cycle is underway) at the LED for the selected
cycle will FLASH (e.g., LC2);
2.1.d.2 STARTING UP THE WASHING CYCLE
AUTOMATICALLY
To start up the cycle AUTOMATICALLY (by opening and
closing the door), you will need to change the cycle start-
up mode. Press and hold the START "S3" button until
the pre-selected cycle LED remains CONSTANTLY LIT
(approx. 7 sec.) and the washing cycle will then start up
AUTOMATICALLY when the door is closed.
= * 207 sec.
Publicidad
