Publicidad
Idiomas disponibles
Idiomas disponibles
2.1.e Instructions during the washing cycle
2.1.e.1 Display information
1) During washing, the tank temperature and the
scrolling of the luminous dots from right to left, are
displayed;
2) During drip-drying, the display only shows the scrol-
ling of the luminous dots;
3) During rinsing, the temperature and the scrolling of
the luminous dots are displayed;
By pressing the START "S3" button again, a new wa-
shing cycle will begin;
For machine with BT
This machine allows to obtain always the same rinse
temperature and pressure through the Break Tank
system.
indeed, if this is not sufficient, the washing cycle is au
tomatically extended so as to provide the necessary
conditions for optimum rinsing at 85°C.
The waiting time required to attain optimum temperature
can extend to a maximum of 8 minutes.
2.1.e.2 Interrupting the cycle
1) It is possible to pause the washing cycle in case of
EMERGENCY, by opening the door;
the message "F1" will appear on the display;
normal operations will resume on closing the door.
2 ) The cycle will also be interrupted by SWITCHING
OFF the machine using the "Q1" button.
3) On switching the machine back on, the LED indicating
the last cycle selected will light up, and the alarm
message "A1" will appear on the display;
this will disappear when a new cycle is begun.
At the end of the washing cycle, take out the basket and
shake it gently so as to remove the last drops left on the
washed items.
Allow items to dry and remove them from the basket
with clean hands.
Store all items on hygienic and completely stable su
faces.
2.1.f Self-washing and Draining
At the end of the washing operations, TURN OFF the
machine pushing the "Q1" button .
Close the machine's door, press the START button "S3"
(approx. 5 sec.).
Keep it pressed until the message "C1" appears on the
display, then release the "S3" button.
The self cleaning and draining cycle will start and the
scrolling from right to left of the luminous dots are
displayed.
For machine with BT
The self cleaning cycle has a total duration of 130 sec-
onds divided as follows:
• phase a: the rinse pump starts running for 70 sec
• phase b: boiler filling starts at the same time for 60
sec.
• phase c: after 15 seconds from the start of the self
cleaning cycle, the washing pump is activate for 3
seconds to expel the residues inside;
• phase d: when the cycle started, the drain pump is
activate until the end og the cycle, the washing tank
is completely emptied.
The end of the cycle is indicated by the message OFF
on the display.
Maximum duration 130 sec.
2.1.g Manual draining
It is possible to empty the tank by carrying out the
manual draining cycle, during which only the drainage
pump mains active.
ATTENTION
This cycle can only be carried out by leaving the machi
ne SWITCHED ON and the tank full of water.
Close the machine's door and press the "S9" or CYCLE
button (approx. 5 sec.).
Keep it pressed until the message "C2" appears on
the display,
EN
17
Publicidad
