Remote Control
CAUTION: This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. The equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on. The user is encouraged
to try and correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and the receiver
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• Consult the dealer or an experienced radio / TV technician for help
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.
Modifications not approved by the party responsible for compliance could void user's authority to operate the equipment. This Class B digital
apparatus complies with Canadian ICES-003.
This remote control requires 1 Lithium Coin Cell Battery (size CR2032), which is included.
Pre-Installation (continued)
TOOLS REQUIRED
(not included)
Safety goggles
HARDWARE INCLUDED
NOTE: Hardware NOT shown to actual size.
AA
Phillips
screwdriver
BB
CC
Power drill
Part
Description
AA
Small Bolt
DD
BB
Large Screw
CC
Wall Anchor
DD
Feet Screws
Quantity
4
4
4
4
5