Axxess AXDIS-TY3 Manual De Instrucciones página 4

PROGRAMMING THE AXDIS-TY3
For the steps below, the LED located inside the interface can only be seen while active. The
interface does not need to be opened to see the LED
1. Start the vehicle.
2. Connect the AXDIS-TY3 harness to the wiring harness in the vehicle.
3. The LED will initially turn on solid Green, then turn off for a few second while detecting the radio.
4. The LED will then flash Red up to (23) times indicating which radio is connected to the
interface, then turn off for a couple seconds. Pay close attention to how many Red flashes
there are. This will help in troubleshooting, if need be. Refer to the LED Feedback section for
more information.
5. After a couple seconds the LED will turn on solid Red while the interface auto detects the
vehicle. The radio will shut off at this point. The process should take 5 to 30 seconds.
6. Once the vehicle has been auto detected by the interface, the LED will turn on solid Green,
then the radio will come back on, indicating that programming was successful.
7. Test all functions of the installation for proper operation, before reassembling the dash. If
the interface fails to function, refer to the Troubleshooting section.
Note: The LED will turn on solid Green for a moment, then turn off under normal operation after
the key has been cycled.
4
AUDIO LEVEL ADJUSTMENT
(amplified models only)
1. With the vehicle and radio turned on, turn the volume up 3/4 of the way.
2. With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio
level; counter clockwise to lower the audio level.
3. Once at a desired level, audio adjustment is complete.