Publicidad
Idiomas disponibles
Idiomas disponibles
B
FILLING THE RINSE AID RESERVOIR
1. Remove the rinse reservoir cap by
lifting up the handle.
3. Close the cap after all.
Adjusting the rinse aid reservoir
To achieve a better drying performance with limited rinse aid, the dishwasher is designed
to adjust the consumption by user. Follow the below steps.
1.
Close the door, switch on the appliance.
2.
Within 60 seconds after the appliance was switched on press the program button ">"
for more than 5 seconds, and then press the Delay button to enter the set model, the
rinse aid indication blinks as 1Hz frequency.
3.
Press the Program button ">" again to select the proper set according to your using
habits, the setting will change in the following sequence: D3->D4->D5->D1->D2->D3.
The higher the number, the more rinse aid the dishwasher uses.
4.
Without operation in 5 seconds or press the Power button to complete the setup and
exit the setting mode.
Using the appliance
27
2. Pour the rinse aid into the
dispenser, being careful not to
overfill.
EN
Publicidad
