Cuisinart soho CPB-7 Serie Instrucciones Y Recetas página 5

CLEANING AND MAINTENANCE
Always unplug your Cuisinart ® Soho
before cleaning. The base and parts are made of corrosion-resistant materials that
are easy to clean. Before first use and after every use, clean each part thoroughly.
Periodically check all parts before reassembly. DO NOT USE if any part is damaged,
or if the cup is chipped or cracked.
To remove blade assembly, twist off by turning counterclockwise. NEVER TOUCH
THE BLADE ITSELF.
CAUTION: Handle the blade assembly carefully. Blades are SHARP and may cause
injury. DO NOT attempt to remove blades from blade assembly.
Wash all parts in warm, soapy water; rinse and dry thoroughly. All parts are top rack
dishwasher safe.
Silicone band is removable for thorough cleaning.
Tip: You may wish to clean your Soho™ Single-Serve Blender as follows: squirt
a small amount of dishwashing liquid into blending cup and fill halfway with warm
water. Attach blade assembly. Blend for 15 seconds. Repeat, using clean tap water.
Carefully disassemble parts and empty blender cup. Rinse and dry all
parts thoroughly.
Finally, wipe the motor base clean with a damp cloth to remove any residue,
and dry thoroughly. Never submerge the motor base in water or other liquids, or
place in a dishwasher.
Any other servicing should be performed by an authorized service representative.
™ Single-Serve Blender from the electrical outlet
TROUBLESHOOTING
Problem Solution
My blender is not Be sure the blade assembly is on the blending cup
turning on or going correctly. Be sure the blending cup is properly installed
into Standby mode. on the base. A light should come on and the unit should
be in Standby mode.
1. Plug blender into an independent outlet.
2. Make sure blender is securely plugged in as indicated
on page 4.
3. Check the outlet for power; try plugging into a
different outlet.
4. Check your home's circuit breaker.
The blender The motor could have overheated. The resettable fuse,
stopped running. which protects the motor due to overloading, may have
been tripped. To reset the appliance, unplug the unit and
let it cool for a minimum of 15 minutes. Then reduce the
contents of the blender and/or clear any jams. Restart
the unit as noted in the operating directions.
The rubber gasket
Run under water and tap on the edge of sink upside
won't come out from down to loosen the gasket.
the blade assembly
for cleaning.
The blade assembly The ingredients cause pressure, and with the airtight
is hard to remove seal, pressure builds up creating a vacuum or a suction
after blending. effect. This is normal.
Unit appears to 1. Check rubber gasket. Make sure it's installed correctly
be leaking.
in the blade assembly.
2. Make sure rubber gasket is not damaged.
5