FR
ASSEMBLY INSTRUCTIONS
FRONT FENDER
Secure the front fender to the fork using the 5mm
Ø12 spacer, M5x20 CHC screw and washer. Tighten
the screw to 6Nm.
Fit the stays to the fender using the base lock nut on
the outside and the TBHC M4x8 screw and washer
on the inside of the fender.
Tighten the nuts to a torque of 4 Nm.
Insert the stays into the bottom of the fork to
complete the front fender assembly.
Secure the stays using the M4x8 screw and tighten
to a torque of 4 Nm.
15