Publicidad
Idiomas disponibles
Idiomas disponibles
REMOTE CONTROL
OPERATING THE SYSTEM
Inserting batteries into the Remote Control
• Insert the batteries (Type R06 or AA) into the remote
control as shown in the battery compartment.
• To avoid damage from possible battery leakage, remove
dead batteries or batteries that will not be used for a
long time. For replacement, use type R06 or AA
batteries.
Important:
Before you begin operating the system, complete the
preparation procedures.
Demonstration mode
The system has a demonstration mode that shows the
various features offered by the system. Whenever the
system is switched on from the wall socket, the
demonstration mode will start automatically.
Note:
- During demonstration mode, if you press any source (or
standby-on) button, the system will switch to the
respective (or standby) mode.
- When the system is switched to standby mode, 5
seconds later, the demonstration mode will resume.
To cancel demonstration mode
• Press and hold
STOP*CLEAR
■ (DEMO) (on the
system only) tor 5 seconds to stop the demonstration.
— The demonstration mode will be switched off.
— The system will switch to standby mode.
Easy Set
EASY SET allows you to store all available radio stations in
a particular band (FM or AM) automatically.
• Press and hold
STANDBY»ON
(on the system only) for
5 seconds; when the system is in standby or
demonstration mode.
— TRSR' RET" will be displayed and followed by
m t i imt
n
11
i u i l_ r v .
— EASY SET will start with the last active band.
— All available radio stations with sufficient signal
strength will be stored or until 40 presets are filled.
14
Publicidad
