Warning! Under no circumstances should you try to
repair the system yourself, as this will invalidate the
warranty.
• If a fault occurs, check the points listed below before
taking the system for repair.
• Should any problems persist after you have made these
checks, consult your nearest dealer or service center.
CD Player Operation
"fJD DISC" is displayed.
• The disc is inserted upside down.
— Place CD with printed side up.
• Moisture condensation at the lens.
— Wait until lens has adjusted to normal room
temperature.
• There is no disc in the CD tray.
— Insert a CD.
• The CD is dirty, badly scratched or warped.
— Clean or replace the CD.
• The CD lens is dirty or dusty
— See section under Maintenance.
Radio Reception
Poor radio reception
• The signal strength is too weak.
—1 Adjust the antenna.
• The TV or VCR is too close to the stereo system.
— Separate the stereo system from the TV or VCR.
— Connect an external antenna for better reception.
Tape Deck Operation
"RECORDING ncriiT" is displayed.
• A recording is in progress.
-* Stop the recording or wait until it is finished.
"TRPC DUBBING
OULU"
is displayed.
• Tape dubbing is only possible in tape mode.
— Switch source to tape mode.
Recording or playback cannot be made or there is a
decrease in audio level.
• Dirty tape heads, capstans or pressure rollers.
— See section on tape deck maintenance.
• Magnetic build-up in the record/playback head.
— Use demagnetizing tape.
General
System does not react when any button is pressed.
• Electrostatic discharge.
Press STANDBY-ON to switch the system off. Remove
the AC power plug from the wall outlet, then reconnect
and switch on the system again.
No or poor sound.
• Volume is not turned up.
— Adjust VOLUME.
• The system is muted.
Press MUTE to switch on the sound.
• The headphones are connected.
— Disconnect the headphones.
• Speakers are not connected or are connected wrongly.
— Check that the speakers are connected correctly.
-* Make sure that the stripped speaker wire is clamped.
TROUBLESHOOT)!^
Reversed left and right sound.
• Speakers are connected wrongly.
— Check the speaker connections and location.
Lack of bass sound or apparently imprecise physical
location of musical instruments.
• Speakers are connected wrongly.
— Check the speaker connection for proper phasing, red/
black wires to red/black terminals.
Remote control has no effect on the system.
• The distance to the system is too large.
— Reduce the distance.
• Batteries are inserted incorrectly.
-* Insert the batteries with their polarities (+/- signs) as
indicated..
• Batteries are exhausted.
— Replace the batteries.
• Wrong source is selected.
— Select the source (CD, TUNER, etc.) before pressing the
function button, (PLAY, PREV/NEXT, etc.).
Timer not working.
• Timer is not switched on.
— Press CLOCK»TIMER to switch on the timer.
• Dubbing/recording is in progress.
— Stop dubbing/recording.
System displays features automatically; buttons
flash continuously.
• Demonstration mode is switched on.
— Press and hold M for 5 seconds to switch off the
demonstration.