Publicidad
Idiomas disponibles
Idiomas disponibles
WIRING
WARNING: To reduce the risk of fire, electrical shock or personal injury, wire connectors provided
with this fan are designed to accept only one 12-gauge house wire and two lead wires from the fan. If
your house wire is larger than 12-gauge or there is more than one house wire to connect to the
corresponding fan lead wires, consult an electrician for the proper size wire connectors to use.
CAUTION: Be sure outlet box is properly grounded and that a ground (green or bare) wire is
present.
WARNING: If house wires are different colors than referred to in the following steps, stop
immediately. A professional electrician is recommended to determine wiring.
WARNING: Using a full range dimmer switch (not included) to control fan speed will cause a loud
humming noise from fan. To reduce the risk of fire or electrical shock, do NOT use a full range dimmer
switch to control fan speed.
NOTE: This fan is remote control adaptable (remote control not included). Please refer to instructions
provided with the remote control before proceeding with these wiring instructions.
Choose wiring diagram (Fig. 1A, Fig. 1B or Fig.
1.
1C) that fits your situation and make appropriate
wiring connections as follows: [IMPORTANT: Use
one of the wire connectors (CC) provided to make
each wire connection, making sure to screw wire
connector (CC) on in a clockwise direction.]
1A. FAN AND LIGHT CONTROLLED BY PULL
CHAINS: Connect BLACK and BLUE wire from
fan to BLACK wire from ceiling. Connect WHITE
wire from fan to WHITE wire from ceiling.
Connect GROUND (GREEN) wires from
downrod (A) and mounting bracket (C) to
BARE/GREEN wire from ceiling.
FAN AND LIGHT CONTROLLED BY PULL CHAINS
FAN AND LIGHT CONTROLLED BY TWO WALL SWITCHES
1A
120V POWER
FROM CEILING
GROUND/GREEN (BARE)
10
BLACK (POWER)
WHITE (NEUTRAL)
GREEN
WHITE
BLUE
BLACK
Publicidad
